ITG-100AI Embedded System
Page 13
Step 3:
To re-install the bottom cover, orient the bottom cover to make the metal piece
inside the cover position on the top of the PCIe accelerator card for heat
dissipation (
Figure 3-2: Bottom Cover Installation
Step 4:
Fasten the four retention screws previously remove to secure the bottom cover.
3.4 SO-DIMM Installation
WARNING:
Using incorrectly specified SO-DIMM may cause permanently damage
the ITG-100AI. Please make sure the purchased SO-DIMM complies
with the memory specifications of the ITG-100AI.
To install a SO-DIMM into a SO-DIMM socket, please follow the steps below.
Step 1:
Remove the bottom cover from the ITG-100AI. Please follow the instruction
described in
Section 3.3
Step 2:
Locate the SO-DIMM socket on the motherboard (
).
Summary of Contents for ITG-100AI
