Mustang-V100-MX8
Page 12
3.3 Hardware Installation
To install the Mustang-V100-MX8, please follow the steps below.
Step 1:
Prepare the computer.
Turn off the computer, and remove the power cord from
the rear of the power supply.
WARNING:
Disconnect the computer from the power supply and from any networks
to which you will install the Mustang-V100-MX8, or you risk damaging
the system or experiencing electrical shock.
Step 2:
Remove the cover from the chassis.
Step 3:
Locate available PCIe slots and remove the blank brackets.
The
Mustang-V100-MX8 is compatible with PCIe x4 slots, and only needs one PCIe
slot for installation. Remove a blank bracket panel on the back of the computer
that aligns with the PCIe slot for installing the Mustang-V100-MX8. Save the
bracket screw.
Low-profile bracket
Full-height bracket
Figure 3-1: Remove One Blank Bracket
Summary of Contents for Mustang-V100-MX8-R10
