NAS-2108RW NETWORK ATTACHED STORAGE SERVICE MANUAL
Chapter 9
FACTORY DEFAULT SETUP
Overview
Create Disk Volume
Create Network Share
Clear Event Logs
Overview
When a system is equipped with the hard drives and about to be shipped out, be
sure to perform below checks:
Create Disk Volume
Pre-configure all the hard drives on the system to a RAID-0 volume.
Create Network Share
Create a default public share folder as mentioned in the user’s manual.
Clear Event Logs
Remove all the event records.
Before performing the factory default setup, start the browser and open the
system administration web page of the NAS-2108RW.
Create Disk Volume
Follow below steps to configure the default disk volume:
1.
In system administration web page, go to “Disk Configuration”. Run
“Create Disk Volume”, and select “RAID 0 Striping Disk Volume.”
IEI CONFIDENTIAL
28
