PAC-1700G QIG IEI Technology Corp. Page 3
INSTALLATION STEPS
To install the PAC-1700G chassis, the following installation steps
must be completed:
Step 1:
Unpack the chassis.
Step 2:
Remove the cover.
Step 3:
Remove the upper compartment.
Step 4:
Install the PSU.
Step 5:
Install the optical drive.
Step 6:
Install the FDD.
Step 7:
Reinstall the upper compartment.
Step 8:
Install the backplane.
Step 9:
Install the HDD.
Step 10:
Connect the cables.
Step 11:
Install the CPU card.
Step 12:
Install the PCI and ISA expansion card.
Step 13:
Reinstall the top cover.
Step 14:
Install the wall-mount plates.
Step 0:
The installation steps outlined above are described in detail below.
Please refer to the relevant section.
STEP 1: UNPACK
The PAC-1700G is shipped in a plastic bag that is placed inside a
cardboard box. The items are also shipped with the chassis. When
you unpack the chassis you must:
Make sure all the items listed in the
PACKING LIST
section are present.
Make sure the chassis has not been damaged in any way.
STEP 2: TOP COVER REMOVAL
The top cover is secured to the chassis with six retention
screws on both sides of the chassis.
Step 1:
Remove all six top cover retention screws from both
sides of the chassis, three from each side.
Figure 2: Top Cover Retention Screws
Step 2:
Slide the cover backwards and then lift the cover up
gently.
Step 0:
Figure 3: Remove the Top Cover
STEP 3: UPPER COMPARTMENT
REMOVAL
The upper compartment is secured to the lower compartment with
four retention screws. To remove the upper compartment, follow the
steps outlined below:
Step 1:
Remove four retention screws, two from the top of the
chassis and two from both sides of the FDD drive bay.
Figure 4: Top Upper Compartment Retention Screws
Figure 5: Upper Compartment Retention Screws on the FDD
Drive Bay
Step 2:
Slide the upper compartment backwards and lift it up
gently.
