1
Revision
Date Version
Changes
December 15, 2017
1.00
Initial release
Intended Use
The POC-W24C-ULT3 medical panel PC is intended to be used to display general
purpose medical images. The device shall not be used for diagnosis purpose or life
supporting system.
Equipment connected to analog or digital interfaces must comply with the respective
IEC Standards (e.g. IEC 60950 for data processing equipment and IEC 60601-1 for
medical equipment). Furthermore all configurations shall comply with the current
version of the standard for SYSTEMS IEC 60601-1-1. Everybody who connects
additional equipment to the signal input part or signal output part configure a
medical system, and is therefore responsible that the system complies with current
version of the requirements of the system standard IEC 60601-1-1. If in doubt,
consult the technical service department or your local representative.
Manual Conventions
WARNING
Warnings appear where overlooked details may cause damage to the
equipment or result in personal injury. Warnings should be taken
seriously.
CAUTION
Cautionary messages should be heeded to help reduce the chance of
losing data or damaging the product.
NOTE
These messages inform the reader of essential but non-critical
information. These messages should be read carefully as any
directions or instructions contained therein can help avoid making
mistakes.
Hot surface
This symbol indicates a hot surface that should not be touched without
taking care.
OPERATING INSTRUCTION
Follow operating instructions or consult instructions for use.
IEC 60417-5009: Stand-by
Summary of Contents for POC-W24C-ULT3
Page 4: ...3 Front Panel Bottom Panel ...
Page 5: ...4 Left Panel Rear Panel ...
