PPC-37xx-N270 Panel PC
Page 90
VT-UTF8 Combo Key Support
These configuration options are discussed below.
Serial Port Number [COM1]
Use the
Serial Port Number
option allows to select the serial port used for remote
access.
COM1 D
EFAULT
System is remotely accessed through COM1
COM2
System is remotely accessed through COM2
NOTE
: Make sure the selected COM port is enabled through the Super I/O configuration
menu.
Base Address, IRQ [2F8h,3]
The
Base Address, IRQ
option cannot be configured and only shows the interrupt
address of the serial port listed above.
Serial Port Mode [115200 8,n,1]
Use the
Serial Port Mode
option to select baud rate through which the console redirection
is made. The following configuration options are available
115200
8,n,1
D
EFAULT
57600
8,n,1
38400
8,n,1
19200
8,n,1
09600
8,n,1
NOTE:
Identical baud rate setting musts be set on the host (a management
computer running a terminal software) and the slave
Summary of Contents for PPC-3708A-N270
