RACK-3200G QIG IEI Technology Corp.
Page 4
Step 2:
To install the connector into the correct location, the
connector must be maneuvered under the elevated
surface at the rear of the chassis and correctly aligned
with the preformed connector hole.
Step 3:
Insert the connector into the corresponding preformed
hole and secure it to the chassis by inserting two
retention screws for each connector.
Figure 6:
Insert the Rear Panel Connector Under the
Rear Bracket
Step 4:
Gently pull the ribbon cable connected to the installed
interface under the elevated surfaces at the rear and
middle of chassis so that the ribbon cable connector can
be easily accessed and inserted into the backplane or
the CPU card after the backplane or CPU card has been
installed.
Step 0:
Figure 7:
Run the Connector Ribbon underneath the
Bracket in the CPU Card Cage
STEP 5: INSTALL THE POWER SUPPLY
UNIT (PSU)
After the rear panel port connectors have been installed, install
the PSU. Compatible IEI PSUs are listed in the table above.
NOTE:
RACK-3200G PSU installation is a complicated process.
Before you proceed with the installation of the PSU, please
read all the installation steps and associated notes listed
below.
A user-supplied power supply unit can be secured to the front of
the chassis with one internal screw and four retention screws that
fasten the PSU to the right side of the chassis. To install the PSU,
please follow the steps below.
Step 1:
Remove the PSU bracket from the chassis. To do this,
please remove both the internal retention screw and the
four retention screws from the right side of the chassis.
Figure 8:
Remove Four PSU Bracket Retention Screws
from the Side
Figure 9:
Remove PSU Bracket Internal Retention
Screw
Output Range
Model No.
Input
Type
Watt
+3.3V
+5V
+12V1
+12V2
-5V
-12V
+5Vsb
ACE-925AP-U-RS
AC AT 250W
N/A 22A 11A N/A 0.5A 0.7A N/A
ACE-940AP-RS
AC AT 390W
N/A 40A 15A N/A 0.3A 0.8A N/A
ACE-832AP-RS
AC ATX
300W
28A 30A 15A N/A 0.3A 0.8A 2A
ACE-841AP-S-RS
AC ATX
400W
28A 33A 20A N/A 0.5A 1A 2A
ACE-850AP-RS
AC ATX
500W
27A 29A 18A 18A 0.3A 0.8A 2A
Table 2: Compatible IEI PSUs.
