TANK-610-BW Em b e d d e d S ys te m
P a g e 9
2.1
Un pa c kin g
To unpack the embedded system, follow the steps below:
S te p 1:
Use box cutters, a knife or a sharp pair of scissors that seals the top side of the
external (second) box.
S te p 2:
Open the external (second) box.
S te p 3:
Use box cutters, a knife or a sharp pair of scissors that seals the top side of the
internal (first) box.
S te p 4:
Lift the system out of the boxes.
S te p 5:
Remove both polystyrene ends, one from each side.
S te p 6:
Make sure all the components listed in the packing list are present.
2.2
P a c kin g Lis t
NOTE:
If any of the components listed in the checklist below are missing, do
not proceed with the installation. Contact the IEI reseller or vendor the
TANK-610-BW was purchased from or contact an IEI sales
representative directly by sending an email tThe TANK-610-BW is shipped with the following components:
Qu a n tity
Ite m a n d P a rt Nu m b e r
Im a g e
1
TANK-610-BW
Summary of Contents for TANK-610-BW
