57
Appendix C.
How to use the Wake-Up Function
The WAFER-E668EV provides two kind of Wake Up Function.
This page describes how to use the Modem Wake-Up and LAN Wake-
Up functions.
Wake-Up function works whilst using ATX power supply,
Wake-Up By Modem Ring On
:
In CMOS SETUP, the user must set the option
Wake Up On
LAN/Ring
to enabled. The ATX power supply will be switched on when
there is a ring signal detected on the pin “RI” of the serial port.
Wake-Up On LAN
:
In CMOS SETUP, the user must set the option
Wake Up On
LAN/Ring
to enabled. When the computer is in power-down status, a
LAN Link/Active LED is flashing. This status indicates that the LAN chip
has entered standby mode and is waiting for a Wake-Up signal. You can
use other computers to wake up your computer by sending ID to it.
ID: ID is the address of your system LAN. Every LAN chip has a factory-
set ID which you can find it from network information in WINDOWS.
ID’s format is xx-xx-xx-xx-xx-xx
Example ID
: 00905C21D4
