WAFER-PV-D5253/D4253/N4553 SBC
Page 43
Before and during the installation of the WAFER-PV-D5253/D4253/N4553
DO NOT:
DO NOT
remove any of the stickers on the PCB board. These stickers are
required for warranty validation.
DO NOT
use the product before verifying all the cables and power connectors
are properly connected.
DO NOT
allow screws to come in contact with the PCB circuit, connector pins,
or its components.
4.3 SO-DIMM Installation
To install an SO-DIMM, please follow the steps below and refer to Figure 4-1.
Figure 4-1: SO-DIMM Installation
Step 1:
Locate the SO-DIMM socket
. (See
Figure 4-2
) Place the board on an
anti-static mat.
Figure 4-2: SO-DIMM Location
Step 2:
Align the SO-DIMM with the socket
. Align the notch on the memory with the
notch on the memory socket.
Summary of Contents for WAFER-PV-D4253
