Print More Materials, All For Application
13
3.2 Hardware Check
Step 1
As shown in the diagram
1.
Connect the device power to
the bench power
Step 2
1.
Under normal condition, all
lights of the device are lit as
shown in the figure
Step 3
1.
Click Manual
2.
Set the unit to 10mm
3.
Click the Z-axis up and down
respectively
Step 4
1.
Set the unit to 10mm
2.
Manually control the XYZ axis
movement through the touch
screen
3.
Observe if it moves normally as
shown
Step 5
1.
Set movement unit 10mm
2.
Control E1 and E2 extrusion by
touch screen
3.
Observe the left and right print
head gear extrusion teeth to see
if they are turning clockwise and
counterclockwise
Step 6
1.Through pre-heat via touchscreen
2.The temperature can be set for the
hot bed, left nozzle, and right nozzle
3.The temperature on the right
represents the set temperature
4.The temperature on the left
represents the actual temperature
5.The recommended hot bed temp
for the first warm-up:50℃±2℃
6.Left and Right Nozzle temp:210℃
±2℃
7.Please be careful of high
temperatures and handle with
caution