Print More Materials, All For Application
33
7.Common Problems and Their Solutions
Only a few common problems are listed, for more questions please contact the technician directly.
7.1 Movement
Problem
Solution
Problem 1: When extruding, the extrusion gear
shake.
Increase the print head temperature or determine
if the head is clogged or needs to be reloaded
with material.
Problem 2: One or two of the X, Y, Z and E axes
cannot be moved, and an alarm sound appears
when you click to move
Check if the limit switch is pressed
Problem 3: Opposite direction of motion
Open firmware and change control code 1 or -1
7.2 Temperature
Problem
Solution
Problem one: click on the heating, the
temperature does not change, a few seconds
later prompted the heating power is insufficient,
check the heating head temperature rise
Attention: temperature measurement careful of
high temperature hot hands
Whether the print head is installed, or whether
the wire is connected
Problem 2: Temperature display "1023"
Print head is not properly installed
