8 - TROUBLES - CAUSES - CURES
SIR 52 MS52 P/F
EN
8 - Pag. 5 / 10
8.4
CLAMPS DEVICE - PROBLEMS
INCONVENIENTS CAUSE
REMEDY
The cylinder does not work. Check the hydraulic system operation.
Failure of a tightening
clamp.
Replace the broken clamp.
CLAMPS DO NOT TIGHTEN
THE BAR
Low pressure
Adjust pressure, see paragraph 5.7.2.
The holding pneumatic
cylinder is jammed.
Release the cylinder as well as the
holding levers.
THE BAR-PUSHER IS NOT
HELD
Failure of the holding rollers. Replace the broken roller.
BAR-PUSHER AND CARRIAGE
DO NOT ENTER THE GUIDE
The clamps unit is
misaligned as to the guide
axis.
Align the unit (apply to IEMCA technical
assistance department).
8.5
GUIDES - PROBLEMS
ERROR CAUSE
CURE
Sprockets jam
Racks and sprocket supports
are dirty.
Clean the concerned parts.
Sprockets close in the wrong
guide
Chips or dirtiness in the
spring and in the sprockets
control rack.
Clean the concerned parts.
Sprocket open during the bar
rotation
Failure of the locking spring.
Replace the spring.
Make sure the sprockets closing phase
occurs correctly.
Bar vibrates excessively thus
causing side skids
Sprockets are out of phase
Sprockets are not closed.
Clean the sprockets closing unit and
make sure the closing phase occurs
correctly.
Summary of Contents for SIR52 MS52 P
