35
2
INSTALLATION PROCEDURE
302.061
Subparameters
0 -
It actuates the feeding on the lathe’s bar stop.
1 -
It actuates the workpiece feeding, by the value set at
Subparameters
“Workpiece lenght”
.
2 -
It actuates a workpiece feeding by the value set at
Subparameters
“Workpiece lenght”
, it stops at a few millimetres from the bar stop, it performs
another feeding until the bar stop, on condition that the FEEDING signal is on.
35
Phase
machining
: > 0
n o . 3 5
F i x e d
w o r k p i e c e
f e e d i n g
C u t t i n g
t o o l
l e n g h t
3
Wo r k p i e c e
l e n g h t
9 7
61_034 Ec.0
parameter 35 = 1
parameter 35 = 2
parameter 7
parameter 7
subparameter
Workpiece length
subparameter
Workpiece length
Summary of Contents for VIP 80
