The informat ion conta ined in th is docu ment is the property of Automat ic Syst ems and is conf ident ial. The rec ip ient is forb idd en to use it for any purpose ot her
than for the use of the products or the execut ion of the project to wh ich th ey refer or to commu nicate it to th ird parties w ithout the pr ior wr itten conse nt of
Automat ic Systems. Document sub ject to change w ithout advance not if icat ion .
SL93x + TBV327-MT-EN
p. 22/39
5.8. Fitting and adjusting the locking mechanism
a. Slacken the lock-nut
(36)
and screw the
lock
(21)
completely onto the
threaded rod (22)
,
b. Unscrew 4 turns.
Unscrew the
sleeve
(23)
, pass the rod through the
plate and tighten the sleeve.
Turn the obstacle rotor (12), p6 so that the lock (21)
lines up with a locking hole (cf. ch.5.5. ).
Turn the sleeve (23) until it is 9 mm above the plate
level and lock it with
nut (24)
.
Screw completely the lock (21).
Slightly tighten
nut
(25)
to hold the
spacer (26)
.
Firmly tighten
nut (27)
against
nut (25)
to lock the
plate (28)
in position.
a b
21
22
23
24
9
mm
25
26
27
28
36
