The informat ion conta ined in th is docu ment is the property of Automat ic Syst ems and is conf ident ial. The rec ip ient is forb idd en to use it for any purpose ot her
than for the use of the products or the execut ion of the project to wh ich th ey refer or to commu nicate it to th ird parties w ithout the pr ior wr itten conse nt of
Automat ic Systems. Document sub ject to change w ithout advance not if icat ion .
SL93x + TBV327-MT-EN
p. 24/39
With the obstacle in its locked position (
lock
21
engaged into a hole), the
contact plate (34)
must lie
on the
hold magnet (35)
.
Check that the
electro-magnet core (31)
does not
touch the steel frame; if so, move the complete lock
assembly away from the frame.
Fix the lock assembly to the plate by tightening
screws (30)
.
In the locked position (activate the lock by pushing
core (31)
and not
contact plate (34)
!), adjust the
lock
(21)
until it is as far as possible into the hole: the
contact plate (34) must smoothly lie on hold magnet
(35), without forcing. If not the case, adjust the hold
magnet support height by means of the
screws (38)
.
Check the same adjustment for the 2 remaining
locking holes.
Fix the lock (21) by firmly tightening
nut (36)
.
Fit the
return spring (37)
.
Adjust the centering of contact plate (34) with respect
to hold magnet (35) by carefully bending the contact
plate’s arm.
Connect the red cable to the contact plate exactly as
shown in the picture.
The cable must be not snag during the movement of
contact plate (34).
34
35
31
frame
38
36
37
34
35
