The informat ion conta ined in th is docu ment is the property of Automat ic Syst ems and is conf ident ial. The rec ip ient is forb idd en to use it for any purpose ot her
than for the use of the products or the execut ion of the project to wh ich th ey refer or to commu nicate it to th ird parties w ithout the pr ior wr itten conse nt of
Automat ic Systems. Document sub ject to change w ithout advance not if icat ion .
SL93x + TBV327-MT-EN
p. 21/39
5.6. Adjusting the obstacle closed point
1. Close and lock the obstacle.
2. Loosen the 6 screws (D) on the conical coupling (4, p6) for 3 mm.
3. Tighten the 3 screws (E) in the upper ring so that the 2 parts of the
coupling are separated.
Note
: if the screws (E) are not supplied, use 3 screws (D).
4. Move the obstacle to its closed position.
5. Unscrew the 3 screws (E) and tighten the other 6 (D).
5.7. Setting the movement limit stops (5, p6)
Note
:
there are no stops for the TBV327turnstile!
Note
: Check that the obstacle operating angle allowed by the stops is greater than the angle set by the
OPENING ANGLE CLOCKWISE
and
OPENING ANGLE ANTI
-
CLOCKWISE
parameters (ch.5.10. ).
1. Switch off the power.
2. Loosen screw (
41
) on cams (
40
) and (
43
).
3. Bring the obstacle to the desired position in one opening direction.
Bring cam (
40
) against stop (
42
), then position the cam 3 mm back from the stop and tighten screw
(
41
).
4. Adjust the second cam (
43
) in the same way for the other opening direction.
5. Start an A
UTOMATIC
S
ETUP
in the control unit (ch.5.10. )
D
E
40
41
43
42
