iesy GmbH
www.iesy.com | sales@iesy.com | Tel.: +49 (2354) 70655 0
Local court Iserlohn | HRA 9826 |
USt-IdNr
: DE339671635 | Managing Director: Dipl.-Ing. Martin Steger
Seite 5 von 27
User Manual V-180131-BHA00
1.3
Safety Instructions
Ground the unit properly
do not use damaged power cords, accessories or peripherals
before cleaning or servicing, disconnect the unit from the power supply by disconnecting
both power cables. Disconnect all connections, the potential equalisation at the front should
only be disconnected if necessary and as a last step
do not place or drop any objects on the unit. Do not insert foreign objects into the appliance
1.4
External Overcurrent Protection
Provide an external overcurrent protection device for the unit. The highest rated value of this device
is 16A.
1.5
Battery Change (optional)
The SDoT servers V3B have a battery compartment on the back of the 19" housing. It is only
necessary to replace the battery once an optional HSM module has been installed.
The administrator can find information on the status of the external battery in the software GUI
under Monitoring » Status information » HSM: External Battery (refer to user manual of the
SDoT Product).
1.
unscrew the cover of the battery compartment with a coin
2.
replace the battery:
AA 3.6 V
up to 2700 mAh
recommended: EVE ER14505V oder Saft LS14500
3.
close the battery compartment again with the cover unscrewed
Observe the general notes on the disposal of rechargeable batteries and batteries of the country in
which the SDoT System V3B is used.
When disposing of batteries, comply with local regulations and laws.