Page 86 of 110
Interface
Table 3-4 (Continued)
IEEE & RS-232 Commands
Command
Function
Parameter(s)
SEQuence:
TEST
Set current step to test number
nn NONE SKIP
SYSTEM:
LOCKout
Lockout keypad from the remote
OFF ON
DISPlay Set
display
type DMEAS
DDEV
DPCT
FRESult Format
result
type
SCI
ENG
TRIGger
Trigger
type
EXT
INT
SRCImp
Set
source
impedance
n(0-3)
LEVELing
Set
voltage
leveling
OFF
ON
CABLecomp
Set
cable
compensation n(0-3)
DISCrete
Allows continuous frequencies
OFF(discrete) ON (cont)
DISTortion
Enable test for distorted AC
OFF ON
MEDIAN
All measurements use median of 3 tries
OFF ON
CALibrate
Invoke
calibration
FULL
SHORt
OPEN
QUIckos
DATE
Set
calibration
date
nn
nn
nnnn
VIEW:
TEST?:
View the test program parameters
TEST
View the single-test’s parameters
nn
SEQuence
View
the
sequence
n
The format of the returned data is as follows:
Step 1: Test<tab.nn or Fn or skip or none><CR>
Step 2: Test<tab.nn or Fn or skip or none><CR>
Continued
through
Step
6
UTILity?
View the utilities programmed
LOCKout?
View the lockout state
DATA?
Returns the non frequency dependent calibration data
DATA?N
Returns the frequency dependent calibration data for cal
frequency N
DCALibration?
Returns calibration date
CAL
Refer to paragaraph 3.4.4, Remote Calibration
STOP
Stops a measurement
Summary of Contents for 1910
