device manual AS-i DP - Gateway
6.1.3 Flash error (code F00 ...
F10)
F00
General flash failure
This error message contains all unsuccessful operations which have to do with the integrated flash device.
More
details can be seen in the following error messages.
F01
Bad flash command
The operating system has received an invalid command for the flash function block.
Possible cause:
Error in the command from the plc.
F02
Flash sector erasure failed
The flash device has not executed the command to erase a flash sector.
Possible cause:
Access to the flash device while it is in the command execution.
Rectification:
Repeat command.
F03
Flash write verify failed
The data which were to be stored by the flash device could not be verified.
Possible cause:
Access to the flash device while it is in the command execution.
Rectification:
Repeat command.
F04
Flash device: timeout
The flash device reports a timeout during a command execution.
Possible cause:
Access to the flash device while it is in the command execution.
Rectification:
Repeat command.
F05
Flash device: command
The flash device has received an invalid command.
Possible cause:
Software error in the operating system.
F06
Flash system timeout
The operating system has found a timeout during the execution of a flash command.
Possible cause:
Access to the flash device while it is in the command execution.
Rectification:
Repeat command.
F07
Erasure PLC sectors in Flash
The attempt to delete the sectors in which the plc program is stored was unsuccessful.
Possible causes:
The sectors were blocked against overwriting (AC1326).
Access to the flash device while it is in the command execution.
Flash device defective.
Rectification:
Repeat
command.
F08
Storage PLCPRG in flash
Storing of the plc program in the flash device was unsuccessful.
Possible causes:
The sectors were blocked against overwriting (AC1326).
Access to the flash device while it is in the command execution.
Flash device defective.
Rectification:
Repeat
command.
F09
Storage NV in flash
Storing of the non-volatile data in the flash device was unsuccessful (%MB... Retain var).
Possible cause:
Access to the flash device while it is in the command execution.
Flash device defective.
Rectification:
Repeat command.
6-35