ifm
Supplementary device manual Interface CANopen in the AS-i controllerE
Special settings
Setting [Number of channels per analogue slave]
93
6
Special settings
6.1
Setting [Number of channels per analogue slave]
The number of channels per analogue slave can be set separately for each of the groups listed below.
A setting always concerns the whole group; a slave-specific assignment is not possible. The settings
are only carried out via the controllerE configuration and programming software CoDeSys. It is not
possible to view and edit these parameters via the display of the controllerE. The CoDeSys software
and the required programming cable are not included in the scope of delivery of the controllerE and
have to be ordered separately.
The source code for the required driver project has to be requested separately from
ifm electronic
gmbh
.
Group
Possible setting values:
[Number of channels per slave]
analogue inputs of AS-i master 1
1 or 4*
analogue outputs of AS-i master 1
1 or 4*
analogue inputs of AS-i master 2
1 or 4*
analogue outputs of AS-i master 2
1 or 4*
* preset value
The following figure shows the visualisation screen in which the settings can be carried out. Click on
[Store Configuration] to store the changed configuration.
