AS-i Gateway with Profinet device interface
49
>
Carry out a projection adaptation
41535
During projection adaptation, the AS-i master stores the configuration of all AS-i slaves currently found
on the AS-i network in its memory and assigns a valid AS-i address to each of them.
The projection adaptation can only be carried out in projection mode:
► [Projection mode] must be checked (→
Set the operating mode of the AS-i master
(
► During a Projection process all output parameter of not connected AS- slaves in the AS-i
master will be reset to their default values (single / A slaves = 0xF, B slaves = 0x7).
To launch the projection adaptation:
1 Select the menu page
►
>
or
>
2 Carry out a projection adaptation
►
Press [Start projection process] button.
>
The projection adaptation is carried out.
If successful:
>
All slaves on the AS-i master are projected.
If not successful:
>
The Online Support Center displays an error message.
►
Remove the error and repeat the process.
>
Set the monitoring functions of the AS-i master
41641
To set the monitoring functions of the selected AS-i master:
1 Select the menu page
►
>
or
>
2 Set the monitoring functions of the AS-i master
►
Set the following parameters as required:
Parameter
Description
Possible values
[Automatic addressing]
Behaviour if AS-i slave is
replaced (
→
Protected mode
(
→ S.
Automatic addressing disabled
Automatic addressing enabled
[Earth fault detection]
Detection of earth faults
Do not detect earth faults in the AS-i system
Detect earth faults in the AS-i system
[Double address detection]
Double address detection
Do not detect AS-i slaves with the same address
Detect AS-i slaves with the same address
>
Selected values are applied.
