AS-i Gateway with Profinet device interface
48
>
5.4.1
AS-i 1 / AS-i 2: Master setup
41537
The menu item [Master setup] provides access to the configuration options of the selected AS-i
master.
>
Set the operating mode of the AS-i master
41640
More information on the operating modes of the AS-i master:
→
Operating modes of the AS-i
master
(
To set the operating mode of the AS-i master:
1 Select the menu page
►
>
or
>
2 Set the operating mode of AS-i master 1 and the behaviour of the connected AS-i slaves
>
Set the following parameters as required:
Parameter
Description
Possible values
[Projection mode]
Active operating mode of the
AS-i master
Projection mode inactive:
AS-i network operates in protected mode (normal mode)
Projection mode active:
AS-i network can be projected.
[No slave reset]
Behaviour of the AS-i slaves
when changing the operating
mode
Slave is reset when changing the operating mode:
When changing the operating mode, the AS-i slaves will be
reset for a short moment (reset or offline phase).
Slave is not reset when changing the operating mode:
When changing the operating mode, the AS-i slaves
continue to operate without interruption.
>
Selected values are applied.
