123
ifm
Programming Manual AS-i Gateway AC14 (4.2.x)
12/2017
Appendix
Library ACnnnn_SYS_CMD.library
>
Table: AS-i master commands
17054
uCommandID
Description / corresponding command
0x0002
DS2
– Digital slave inputs and master flags
0x0003
DS3
– Analogue inputs of the slaves 1(A)...15(B)
0x0004
DS4
– Analogue inputs of the slaves 16(A)...31(B)
0x0005
DS5
– Digital slave outputs
0x0006
DS6
– Analogue outputs of the slaves 1(A)...15(B)
0x0007
DS7
– Analogue outputs of the slaves 16(A)...31(B)
0x0008
DS8
– Status flags of the analogue outputs of slaves 1...31
0x0009
DS9
– Slave lists LAS, LDS, LPF, LCE
0x000A
DS10
– Slave list LPS
0x000B
DS11
– Current configuration data (CDI)
0x000C
DS12
– Projected configuration data (PCD)
0x000D
DS13
– Image of the input parameters of the slaves (PI)
0x000E
DS14
– Image of the outputs parameters of the slaves (PP)
0x000F
DS15
– Slave error counter, configuration error counter, AS-i cycle counter
0x0011
DS17
– AS-i master: Error lists LCEMS, LCEAS, LDAE
0x1001
Command 0x0001
– Change AS-i slave parameters
0x1003
Command 0x0003
– Project current AS-i network
0x1004
Command 0x0004
– Change LPS
0x1005
Command 0x0005
– Change the operating mode of the AS-i master
0x1006
Command 0x0006
– Change AS-i slave address
0x1007
Command 0x0007 - Set auto address mode of the AS-i master
0x1009
Command 0x0009
– Change extended ID1 in the AS-i slave
0x100A
Command 0x000A - Change PCD
0x100D
Command 0x000D
– AS-i master supply voltage, symmetry, earth fault
0x1015
Command 0x0015
– Read ID string of an AS-i profile (S-7.4)
0x101A
Command 0x001A
– Read AS-i master info
0x101C
Command 0x001C
– Deactivate slave reset when changing to the protected mode
0x1021
Command 0x0021 - Read diagnostics string of an AS-i slave (S-7.4)
0x1022
Command 0x0022 - Read parameter string of an AS-i slave (S-7.4)
0x1023
Command 0x0022 - Write parameter string of an AS-i slave (S-7.4)
0x1024
Command 0x0024
– CTT2 standard read
0x1025
Command 0x0025
– CTT2 standard write
0x1026
Command 0x0026
– CTT2 vendor specific read
0x1027
Command 0x0027
– CTT2 vendor specific selective write
0x1040
Command 0x0040
– CTT2 device group read
0x1041
Command 0x0041
– CTT2 device group write
0x1042
Command 0x0042
– CTT2 vendor specific selective read from buffer
0x1043
Command 0x0043
– CTT2 vendor specific selective write from buffer
