3-segment signal light
DV13x0 DV23x0
11
Byte 0
Bit 3
Byte 0
Bit 2
Byte 0
Bit 1
Byte 0
Bit 0
Colour
0
0
0
0
off
0
1
0
0
red
0
0
1
0
green
0
1
1
0
orange
0
0
0
1
blue
0
1
0
1
purple
0
0
1
1
turquoise
0
1
1
1
white
1
0
0
0
yellow
Byte 0
Bit 6
Byte 0
Bit 5
Byte 0
Bit 4
Frequency
0
0
0
permanently on
0
0
1
low flash rate slow
0
1
0
low flash rate medium
0
1
1
low flash rate fast
1
0
0
high flash rate slow
1
0
1
high flash rate medium
1
1
0
high flash rate fast
8.2 Operation of the standard version
The unit is connected to the digital outputs of the controller via an 8-pole cable (see accessories at
). The HTTL inputs of the signal lamp are triggered with 24 V DC. According to the set
parameters the LED segments are on and the buzzer sounds (if present).
The signal inputs can be triggered either in PNP or in NPN technology (
Ò
Electrical connection > Pin
configuration > Standard unit).
With the parameter setting button the following properties can be set for every LED segment:
•
Colour (red, green, orange, blue, purple, turquoise, white, yellow, off)
•
Frequency (permanently on, low flash rate slow/medium/fast, high flash rate slow/medium/fast)
•
Brightness (100 %, 75 %, 50 %, 25 %)
Parameter setting via the IO-Link interface (pin 8 of the M12 connector) is also possible.
After parameter setting the unit goes to the Run mode.
8.3 Demo mode
In demo mode, the unit demonstrates the different
•
Colours
•
Buzzer sounds (buzzer styles, provided the unit features a buzzer)
Set the parameter [Demo mode] in the IO-Link parameter setting tool. For SIO and IO-Link mode, the
demo is available in 3 different speeds, respectively.
GB
