ifm
Device manual AS-i M4 Gateway Profibus DPV1 (AC1375, AC1376)
2012-02-23
Menu
Main menu [Master Setup]
105
7.6
Main menu [Master Setup]
5475
Set operating modes master.
Menu tree
Explanation
Master Setup
-- AS-i Master 1
Master setup AS-i master 1.
Master setup
-- AS-i Master 1
-- -- Config all
AS-i master 1: Config. all (password level 1 required).
Prerequisites:
- master operating mode = project,
- no slave with the address 0 on the bus.
> Safety query: "Are you sure?"
►
After [OK]:
> The device checks all connected slaves (only on this master)
and enters them as "projected" in its table.
> The master operating mode remains on "Config.".
Master Setup
-- AS-i Master 1
-- -- Operation Mode
AS-i Master 1: Operating mode (password level 1 required)
(
chapter How to switch the operating modes for the AS-i master.
(
→
page
)).
> Display of the current setting.
►
Press [ ] or [ ] to scroll between the operating modes...
- protected,
- project.
Master Setup
-- AS-i Master 1
Operation Mode
-- -- -- Protect. Mode
Operating mode "protected":
> LED [PROJ] goes out.
> Changes to the slaves are detected (LED [CONF/PF] lights).
Slaves with a different projected profile are not activated.
Master Setup
-- AS-i Master 1
-- -- Operation Mode
-- -- -- Config. Mode
Operating mode "Config.":
> LED [PROJ] lights.
> Changes to the slaves are detected (LED [CONF/PF] lights). All
connected slaves are active.
Master Setup
-- AS-i Master 1
-- -- Autoaddr. Mode
AS-i Master 1: Mode "automatic addressing" (password level 1
required):
> Display of the current setting.
►
Press [ ] or [ ] to scroll between ON and OFF.
►
Adopt with [OK].
Automatic addressing ON:
Permits the replaced slave to be assigned the address of the old
slave in the protected mode (default).
Automatic addressing OFF:
The replaced slave must be manually set to the right address.
