ifm
Device manual AS-i M4 Gateway Profibus DPV1 (AC1375, AC1376)
2012-02-23
Set-up
Configuration of the slaves
123
Easy Startup
Master 1 waiting for slave 0
Last Address:
Next Address: 1/1A
23
ESC
Step 8:
AC1375: Menu screen number = 11
> The device is waiting for a slave with the address 0 to be activated on
or connected to master 1.
> Display of the slave address assigned last (or blank field).
> Display of the next free slave address.
►
Take one slave which still has the address 0 and connect it to the AS-i
bus or activate it.
Easy Startup
Master 1 waiting for slave 0
Last Address: 1
Next Address: 2/2A
23
ESC
Step 9:
AC1375: Menu screen number = 11
> The device automatically assigns the next available slave address
(previously displayed) to this new slave.
> The device displays the address assigned to the new slave and,
below, the next available slave address.
> LED [PWR/COM] no longer flashes, but lights: At least one active
slave is now correctly detected.
> LED [CONF/PF] lights: There is (at least) one new slave on the bus
which is not yet in its projection list.
When all slaves have been addressed:
►
Return to the start screen with [ESC].
NOTE
►
Only connect one new slave at a time in the "Easy Startup" mode!
> When the device has completed the integration of the new slave, the display "Waiting for Slave 0"
reappears.
►
Note down the address assigned under "Last address" for this slave.
►
Then you can connect the next slave with the address 0.
►
Finally "Config. all" to add the new slaves to the list of projected slaves,
chapter Enter detected
slaves in the configuration list (
→
page
).
