ifm
Device manual AS-i M4 Gateway Profibus DPV1 (AC1375, AC1376)
2012-02-23
Set-up
Configuration of the slaves
128
9.1.4
Finish configuration
5511
Now all slaves are present on the bus with the correct address.
But the error message (the symbol "
!
") keeps on flashing and the LED [CONF/PF] lights?
Cause: The device has detected all slaves on the bus but the slaves - at least not all of them - are not
yet in the "List of projected slaves" LPS.
This means: The error message "configuration error" is displayed as long as there is a difference
between the detected and configured slaves.
Remedy: In the mode "Quick Setup" enter all detected slaves in the configuration list by pressing a
key.
Info
Password level 1 required:
chapter Password setting (
→
page
.
[MENU] > [Slave Lists] > select master > [Detected Slaves]
E25 ASi1
Config. Error
MENU
1/2
!
USER
Step 1:
> The display on the left appears instead of the
ifm
start screen:
"Configuration error",
chapter Error screen (
→
page
> LED [CONF/PF] lights.
►
Press the key [MENU].
.
PLC Setup
Slave Lists
Address Slave
OK
1
!
ESC
Step 2:
> Device displays the menu item used last.
►
Press [ ] to scroll to [Slave Lists].
Reason: Check the configuration made so far in the list of detected
slaves LDS.
.
PLC Setup
Slave Lists
Address Slave
OK
1
!
ESC
Step 3:
►
Select [Slave Lists] with [OK].
AC1375: continue with step 6.
