ifm
Device manual AS-i M4 Gateway Profibus DPV1 (AC1375, AC1376)
2012-02-23
Contents
3
7.3
Main menu [Slave Lists]............................................................................................. 101
7.4
Main menu [Address Slave]....................................................................................... 102
7.5
Main menu [Diagnostics] ........................................................................................... 103
7.6
Main menu [Master Setup]......................................................................................... 105
7.7
Main menu [Fieldbus Setup] ...................................................................................... 107
7.8
Main menu [Slave Info] .............................................................................................. 109
7.9
Main menu [Slave Setup]........................................................................................... 110
7.10
Main menu [System Setup]........................................................................................ 112
7.11
Main menu [System Info] ........................................................................................... 115
8
Switch operating modes
8.1
Which operating modes are available for the AS-i master? ...................................... 116
8.2
How to switch the operating modes for the AS-i master............................................ 117
9
Set-up
9.1
Configuration of the slaves ........................................................................................ 119
9.1.1
Permissible slave addresses ................................................................................ 120
9.1.2
Automatic individual addressing of slaves............................................................ 121
9.1.3
Manual slave addressing...................................................................................... 124
9.1.4
Finish configuration............................................................................................... 128
9.1.5
Enter detected slaves in the configuration list ...................................................... 131
9.2
Change slave parameter data ................................................................................... 133
9.3
Password protection .................................................................................................. 136
9.3.1
General ................................................................................................................. 136
9.3.2
Password levels.................................................................................................... 137
9.3.3
Password setting .................................................................................................. 138
9.4
Reset to factory preset............................................................................................... 140
9.5
Update firmware......................................................................................................... 142
9.6
Character sets............................................................................................................ 142
9.7
Set the parameters of the fieldbus interface in the device......................................... 143
9.8
Parameter setting of the Profibus host ...................................................................... 145
9.8.1
Introduction ........................................................................................................... 145
9.8.2
Assigning the addresses of the inputs/outputs to the host "locations" ................. 147
9.8.3
Define Profibus DP modules ................................................................................ 156
9.8.4
Device-specific Profibus DP parameters .............................................................. 169
9.8.5
Finish set-up ......................................................................................................... 171
10
DP module 7 – command channel
10.1
Commands in DP module 7....................................................................................... 172
10.1.1
Module 7, command 01 – Read master flags....................................................... 173
10.1.2
Module 7, command 02 – Change operating mode ............................................. 174
10.1.3
Module 7, command 03 – Read current slave configuration................................ 175
10.1.4
Module 7, command 04 – Read projected slave configuration ............................ 177
10.1.5
Module 7, command 05 – Change projected slave configuration ........................ 179
10.1.6
Module 7, command 06 – Read slave parameters............................................... 181
10.1.7
Module 7, command 07 – Change projected slave parameters........................... 182
10.1.8
Module 7, command 08 – Read LAS (list of active slaves) .................................. 184
10.1.9
Module 7, command 09 – Read LDS (list of detected slaves) ............................. 186
10.1.10
Module 7, Command 10 (0Ahex) – Read LPF (list of slaves with
peripheral fault).................................................................................................... 188
10.1.11
Module 7, command 11 (0Bhex) – Read LPS (list of projected slaves)............... 190
