ifm
Device manual AS-i M4 Gateway Profibus DPV1 (AC1375, AC1376)
2012-02-23
DP module 12: extended command channel
Error codes in the module 12
209
11.2
Error codes in the module 12
5681
11.2.1
General error codes
5682
Revision: 2010-0-25
Value [hex]
Meaning
01
no slave response OR:
master is in the offline mode when requesting the command
02
no slave with the old address found
03
slave with address 0 connected
04
slave with the new address already exists
05
error when deleting the old address
06
error when reading the IO configuration
07
error when writing the new address or extended ID code 1
08
new address could only be saved temporarily
09
extended ID code 1 could only be saved temporarily
0A
the slave is not in the LAS
0B
parameter or address invalid
0C
faulty S-7.4 protocol sequence
0D
S-7.4 protocol aborted (timeout)
0E
invalid AS-i slave address for the S-7.4 protocol (e.g. B slaves)
0F
AS-i slave has completed the S-7.4 string
10
AS-i S-7.4 no longer connected (no longer in LAS)
11
another S-7.4 transfer to the addressed AS-i slave is already active
12
the previous segmented S-7.4 transfer was not yet completed
13
invalid S-7.4 data length
14
master is in the wrong operating mode *)
16
timeout during command processing
17
start requirements for S-7.4 command not met:
- wrong slave profile (is not S-7.4) or:
- slave is not in LAS or:
- master is not in the Protected mode
18
master is not in the protected mode
19
master is not in the normal mode
20
command could not be processed within the specified time
E0...EF
error detected by AS-i slave;
CTT2 error codes (
→
page
F0
invalid CTT2 command
F1
invalid CTT2 response
F2
7.5 data length longer than 30 bytes
