ifm
Device manual AS-i M4 Gateway Profibus DPV1 (AC1375, AC1376)
2012-02-23
Function
Introduction AS-i data
35
Extended ID code 2 for analogue slaves with profile 7.4.x
5358
The extended ID code 2 is used to specify complex slaves.
Structure slave profile = S-7.3.[ext. ID code2]
Bit 3
(8
hex
)
Bit 2
(4
hex
)
Bit 1
(2
hex
)
Bit 0
(1
hex
)
Meaning
0 0
1-channel
slave
0 1
2-channel
slave
1 0
4-channel
slave
1
1
4-channel slave (if slave has no extended ID code)
0
0
0
0
4 binary 4 binary outputs
0
output
slave
1
input
slave
The ID code 2 results from a combination of the options stated above.
Valid combinations IO code / ID code / extended ID code 2
5359
Structure slave profile = S-[IO code].[ID code].[ext. ID code2]
IO code
(hex)
ID code
(hex)
ext. ID
code
2
(hex)
Meaning
0…E
not: 9, B, D
0
x
binary I/O connections for sensors and actuators
0, 3, 8
1
x
1 or 2 binary sensors or actuators with 2 signals each (dual-signal devices)
0
1
x
4 binary inputs for 2 dual-signal sensors
0…E
not: 2A
A
x
slave operates in the "extended addressing mode" (B slave or A/B slave)
0 A
E
slave with extended address function:
4 binary inputs for 2 dual-signal sensors (e.g. I/O module AC2250)
0
B
x
slave corresponds to Safety-at-Work
0…E
F
x
manufacturer-specific device (cannot be replaced by other products)
1 1
x
single sensor with remote setting:
3 binary 1 binary output (e.g. sensor OC5226)
3 1
x
2 binary inputs for 1 dual-signal sensor AND
2 binary outputs for 1 dual-signal actuator
3
A
x
slave with extended address function
3 A
1
slave with extended address function:
2 binary 1 binary output
3 A
2
slave with extended address function:
4 binary inputs
6 0
x
quick combined transaction type 5 of 8, 12 or 16 data bits by using 2, 3 or 4 slave
addresses in a slave
7
0
F
motor starter 2I + 2O (e.g. ZB0032)
7
0
E
4 binary 4 binary outputs (e.g. I/O module AC2251)
7 1
x
interface for the transmission of 6...18-bit signals;
analogue profile for combined transaction type 1;
was replaced by S-7.3
