119
ifm
Device Manual SmartSPS AC14 with EtherNet/IP interface (AC1421, AC1422), Firmware 3.1.2
2015-11-30
Setup
Exchange AS-i slave
>
6.7
Exchange AS-i slave
10249
AC142n makes it possible to replace an AS-i slave by a new AS-i slave in the operating mode
"protected mode".
Requirements:
>
The new and the old AS-i slave have the same device profile(→
Profiles of the AS-i slaves
>
The new AS-i slave has the address
0
.
>
Parameter [Automat. adressing] is activated (→
Set the monitoring functions of the AS-i master
(→ page
1 Remove old AS-i slave
►
Disconnect the AS-i slave to be replaced from the AS-i network
>
AC142n detects a configuration error and generates a corresponding OSC message.
2 Install new AS-i slave
►
Connect the new AS-i slave to the AS-i network.
>
AC142n detects the new AS-i slave and automatically assigns the address of the old AS-i slave.
>
The OSC error message disappears.
>
The new AS-i slave is operational.
