260
ifm
Device Manual SmartSPS AC14 with EtherNet/IP interface (AC1421, AC1422), Firmware 3.1.2
2015-11-30
Appendix
Fieldbus EtherNet/IP
>
Command 266 (0x010A) – Set parameters of the NTP server
16707
Using this command, the IP parameters of the NTP server can be set.
>
Command request channel (fieldbus master >>> device)
16705
Offset
Word no.
bit
15
14
13
12
11
10
9
8
7
6
5
4
3
2
1
0
1
UID
2
command number
3
NTP Offset
reserved
NTP
4
NTP server IP address (high byte, net address)
NTP server IP address
5
NTP server IP address
NTP server IP address (low byte, host address)
6 ... 120
The area is completely ignored.
It does not matter whether the data area exists or what data is contained.
Legend:
NTP
Setting the NTP client
1 bit
0x0 = NTP client is inactive
0x1 = NTP client is active
NTP Offset
NTP server provides the
time in UTC. NTP Offset
indicates the difference
between UTC and local
time.
1 byte
0x00 = system clock in local time
0x01 = UTC -12:00
0x02 = UTC -11:00
0x03 = UTC -10:00
0x04 = UTC -09:00
0x05 = UTC -08:00
0x06 = UTC -07:00
0x07 = UTC -06:00
0x08 =.UTC -05:00
0x09 = UTC -04:00
0x0A = UTC -03:30
0x0B = UTC -03:00
0x0C = UTC -02:00
0x0D = UTC -01:00
0x0E = UTC +00:00
0x0F = UTC +01:00
0x10 = UTC +02:00
0x11 = UTC +03:00
0x12 = UTC +03:30
0x13 = UTC +04:00
0x14 = UTC +04:30
0x15 = UTC +05:00
0x16 = UTC +05:30
0x17 = UTC +05:45
0x18 = UTC +06:00
0x19 = UTC +06:30
0x1A = UTC +07:00
0x1B = UTC +08:00
0x1C = UTC +09:00
0x1D = UTC +09:30
0x1E = UTC +10:00
0x1F = UTC +11:00
0x20 = UTC +12:00
