30
ifm
Device Manual SmartSPS AC14 with EtherNet/IP interface (AC1421, AC1422), Firmware 3.1.2
2015-11-30
Operation
Page view
>
Slave selector
Overview of slave states .........................................................................................................................31
Overview of free slave addresses ..........................................................................................................33
7018
The slave selector is used to select an AS-i slave or an AS-i address.
Legend:
Indicator of AS-i master operating mode
AS-i address symbol
Highlighted AS-i address (focus)
Status message of highlighted AS-i address
>
The
status LED
indicates the active operating mode of the AS-i master:
= AS-i master in protected mode
= AS-i master in projection mode
>
Every field represents an
AS-i address
. An AS-i address can be occupied by:
– a single slave symbol
– an A/B slave pair symbol
>
The row and column headers help to locate the AS-i address.
Example: address of the field selected in the picture
– row header:
1x
(= tens digit of the AS-i address)
– column header:
8
(= units digit of the AS-i address)
– type of slave: single slave (= symbol fully occupies the address field)
– resulting AS-i address:
18
>
The symbol of the A/B slave pair appears when an A or B slave is used on this address.
The slave selector is used in the following overviews:
Overview of slave states (
→
Overview of slave states
(
Overview of free slave addresses (
→
Overview of free slave addresses
(
