89
ifm
Device Manual SmartSPS AC14 with EtherNet/IP interface (AC1421, AC1422), Firmware 3.1.2
2015-11-30
Menu
Interfaces
>
5.5.1
Interfaces: Configuration interface
7279
The [Configuration interface] menu provides access to the settings of the EtherNet configuration
interface (port X3).
>
Notes on IP settings
14856
The device provides the following options for configuration of the Ethernet configuration interface:
Manual =
The operator sets the interface parameters (IP address, network
mask, gateway address) manually.
Automatic =
The interface parameters are set automatically. The operator can
choose between these protocols:
– Dynamic Host Configuration Protocol (DHCP)
– Zero Configuration Networking (Zeroconf)
To display the current configuration method and the active IP parameters of the configuration
interface:
1 Select the menu page
►
>
►
Select [IP setup] tab.
2 Show the active settings
>
The parameters below show the active settings:
Parameter
Meaning
Possible values
[Optain IP address
autom.]
Active method for the
configuration of the interface
parameters
=
Manual assignment of interface parameters
through operator
=
Automatic assignment of interface parameters
[IP status]
Configuration protocol used
Static
=
The operator sets the IP parameters
manually.
DHCP
=
The IP parameters are set by a DHCP
server.
Zeroconf
=
The IP parameters are set automatically
with the Zeroconf protocol.
[IP address]
IP address of the interface
e.g.
192.168.0.100
[Subnet mask]
Network mask of the network
segment
e.g.
255.255.255.0
[Gateway address]
IP address of the network
gateway
e.g.
192.168.0.1
►
Select one of the following options:
–
Configure the IP parameters manually
(→ page
–
Configure the IP parameters automatically
