150
ifm
Device Manual SmartSPS AC14 with EtherNet/IP interface (AC1421, AC1422), Firmware 3.1.2
2015-11-30
Appendix
AS-i slaves
>
Valid combinations IO code / ID code / extended ID code 2
5359
Structure slave profile = S-[IO code].[ID code].[ext. ID code2]
IO code
[hex]
ID code
[hex]
Ext.
ID code 2
[hex]
Meaning
0…E
not: 9, B, D
0
x
binary I/O connections for sensors and actuators
0, 3, 8
1
x
1 or 2 binary sensors or actuators with 2 signals each (dual-signal devices)
0
1
x
4 binary inputs for 2 dual-signal sensors
0…E
not: 2A
A
x
slave operates in the "extended addressing mode" (B slave or A/B slave)
0
A
E
slave with extended address function:
4 binary inputs for 2 dual-signal sensors (e.g. I/O module AC2250)
0
B
x
slave corresponds to Safety-at-Work
0…E
F
x
manufacturer-specific device (cannot be replaced by other products)
1
1
x
single sensor with remote setting:
3 binary 1 binary output (e.g. sensor OC5226)
3
1
x
2 binary inputs for 1 dual-signal sensor AND
2 binary outputs for 1 dual-signal actuator
3
A
x
slave with extended address function
3
A
1
slave with extended address function:
2 binary 1 binary output
3
A
2
slave with extended address function:
4 binary inputs
6
0
x
quick combined transaction type 5 of 8, 12 or 16 data bits by using 2, 3 or 4 slave
addresses in a slave
7
0
F
motor starter 2I + 2O (e.g. ZB0032)
7
0
E
4 binary 4 binary outputs (e.g. I/O module AC2251)
7
1
x
interface for the transmission of 6...18-bit signals;
analogue profile for combined transaction type 1;
was replaced by S-7.3
7
2
x
extended slave profile for the transmission of 6...18-bit signals;
extended analogue profile for combined transaction type 1;
was replaced by S-7.4
7
3
x
slave profile for 16-bit transmission with integrated support in the master;
integrated analogue profile for combined transaction type 1
(
Extended ID code 2 for analogue slaves with profile 7.3.x
(
→ page
7
3
5
2 analogue outputs of 16 bits each (e.g. I/O module AC2618)
7
3
6
4 analogue outputs of 16 bits each (e.g. I/O module AC2518)
7
3
C
1 analogue input of 16 bits (e.g. sensor PPA020)
7
3
D
2 analogue inputs of 16 bits each (e.g. I/O module AC2616)
7
3
E
4 analogue inputs of 16 bits each (e.g. I/O module AC2516)
7
4
x
extended slave profile for 16-bit transmission with integrated support in the master;
integrated extended analogue profile for combined transaction type 1
(
Extended ID code 2 for analogue slaves with profile 7.4.x
(
→ page
7
4
C
RFID identification system for writing and reading RFID tags
15-bit data + 1-bit messages (e.g. DTA100)
