18
ifm
Device Manual SmartSPS AC14 with EtherNet/IP interface (AC1421, AC1422), Firmware 3.1.2
2015-11-30
System description
Information concerning the device
>
3.2.5
Interfaces
15839
The device provides the following interfaces:
>
Ethernet configuration interface
6982
The configuration interface (X3) is located behind the front flap of the device. It allows the user to
access the following device functions:
web interface for device configuration and diagnosis
programming of the device-internal PLC using CODESYS
Configuration as fieldbus interface
Possible network topologies:
→
Configuration interface: connection concepts
(
Technical data:
→
Interfaces
(
>
EtherNet/IP fieldbus interface
12113
The device communicates with the higher-level control instance of the EtherNet/IP network via the
EtherNet/IP interface (X6/X7).
Notes regarding connetion concepts:
→
Configuration interface: connection concepts
(
Technical data:
→
Interfaces
(
>
SD card slot
9135
The SD card slot (X5) is located behind the front flap of the device. The following actions can be
performed with an SD card:
update the firmware of the device
save/restore the device configuration
Technical data:
→
Interfaces
(
>
3.2.6
Required accessories
6926
To be able to operate the device in a sensible way you need the following accessories (not supplied
with the device):
Depending on the selected voltage supply (
Operating instructions) you need:
a power supply for the 24 V power supply (e.g. art. no. DN3011)
for each AS-i master one AS-i power supply each (e.g. art. no. AC1236)
a data decoupling module AC1250 (accessory, optional)
AS-i slaves.
