193
ifm
Device Manual SmartSPS AC14 with EtherNet/IP interface (AC1421, AC1422), Firmware 3.1.2
2015-11-30
Appendix
Fieldbus EtherNet/IP
>
Configuration of the analogue channels in slots 9 ... 12
12471
The configuration of the EtherNet/IP device parameters [Analog. channels/I-slave] and [Analog.
channels/O-slave] determines which analogue channels of the AS-i slaves are transmitted. The
following table shows the meaning of the adjustable parameter values:
Parameter values
Description
4 channels
Variable slave assignment
The analogue channels of max. 30 slave addresses are transferred:
single slaves: channels 1...4
or:
A slaves: channels 1+2 and
B slaves: channels 1+2
The device-specific parameters (
→
Device-specific parameters
(
)) of the device allow you to
individually define the order of 15 of the analogue slaves to be transferred, respectively (
→
Table: variable
slave assignment for slots 9 ... 12
(
→ page
)). All available slave addresses of both AS-i masters can be
selected.
Preset, variable:
for slot 9: AS-i master 1: single slaves 1 ... 15 or: slave 1A ... 15A, 1B ... 15B
for slot 10: AS-i master 2: single slaves 1 ... 15 or: slave 1A ... 15A, 1B ... 15B
for slot 11: AS-i master 1: single slaves 16 ... 30 or: slave 16A .... 30A, 15B ... 30B
for slot 12: AS-i master 2: single slaves 16 ... 30 or: slave 16A .... 30A, 15B ... 30B
2 channels
Fixed slave assignment
Of each transferring AS-i single and A address, the following analogue channels are transmitted:
of single slaves: channels 1+2
or:
of A slaves: channels 1+2
The slave assignment is fixed (
→
Table: Fixed slave assignment for slots 9 ... 12
(
)). A
configuration of the slave order in the device-specific parameters is ineffective.
1 channel
Fixed slave assignment
Of each transferring AS-i single and A address, the following analogue channels are transmitted:
single slaves: channel 1
or:
A slaves: channel 1
The slave assignment is fixed (
→
Table: Fixed slave assignment for slots 9 ... 12
(
)). A
configuration of the slave order in the device-specific parameters is ineffective.
1 channel A/B-Slave
Fixed slave assignment
Of each transferring slave address, the following analogue channels are transmitted:
single slaves: channels 1+3
or:
A slaves: channel 1 and B slaves: channel 1
The slave assignment is fixed (
→
Table: Fixed slave assignment for slots 9 ... 12
(
)). A
configuration of the slave order in the device-specific parameters is ineffective.
