31
ifm
Device Manual SmartSPS AC14 with EtherNet/IP interface (AC1421, AC1422), Firmware 3.1.2
2015-11-30
Operation
Page view
>
Overview of slave states
6992
>
The slave selector shows an overview of the slaves in the
selected AS-i network.
>
The symbol colour signals the slave status. Meaning of
symbols and colours:
→
Slave status: colour code + symbols
(
>
The text field displays the status of the selected AS-i slave.
Possible status messages:
-
Slave active
-
Not projected
(= configuration error)
-
Double address
(= double address error)
-
Periphery
(= periphery fault)
Use:
1 Select an AS-i slave
►
Use the arrow keys [
], [
], [
] and [
] to select the desired AS-i slave.
>
The focus (= orange frame) is on the selected AS-i slave.
>
The info bar shows the address of the selected AS-i slave.
>
The text field shows a status message about the selected AS-i slave.
2 Activate the selected AS-i slave
►
Use function key [Select] to activate the selected AS-i slave and go to the next menu page.
OR:
Use function key [Back] to cancel and leave the slave selector.
>
Slave status: colour code + symbols
11236
Single slave
A/B slave
Colour
Meaning
grey
No slave found:
slave address is neither in the LPS nor in the LDS
green
Slave is activated ( in LAS)
red
Configuration error type 1:
– slave is projected (in LPS) but was not found (in LDS)
yellow
Slave signals a peripheral fault
pink
Several slaves have the same address (double address error)
grey red
Configuration error type 2:
– the found slave (in LDS) is not projected (in LPS)
– the found slave has another profile than projected
