page 21
ENGLISH
Teil 2:
Changing parameters
Part 3:
Storing changed
parameters
Changing stored parameters in the PP2000
4
Mode/Enter Set
Mode/Enter Set
Mode/Enter Set
Press the
Mode/Enter
button
several times until the
respective
parameter
is displayed.
Press the
Set
button and keep
it pressed. The current
parameter
value flashes
for 5s,
then
the value
is increased
*
(incremental by pressing briefly or
scrolling by holding pressed).
Press the
Mode/Enter
button
briefly
(= acknowledgement).
The parameter is displayed again,
the set parameter value is set the
working memory.
5
6
7
Change more parameters:
Start again with step 4.
Storing parameters:
You can store the parameters at
any time (
→
part 3).
*Decrease the value: Let the display of the parameter value move to the
maximum setting value. Then the cycle starts again at the minimum setting
value.
8
Mode/Enter Set
Mode/Enter Set
Press the
Mode/Enter
button
several times until the “
Sto
“ is
displayed.
Press the
Set
button and keep
it pressed.
“
nr
”
flashes
for 5s,
then the available memory
locations are displayed one after
the other*
(incremental by pressing briefly or
scrolling by holding pressed).
9
10
*A read-only memory with three memory locations is available:
nr1
,
nr2
,
nr3
.
**Cancel:If you do not want to store the data record, wait for 15s.
The unit quits the menu item and displays "
SEL
" again.
Mode/Enter Set
As soon as the requested memory
location is displayed press the
Mode/Enter
button
briefly
(=
acknowledgement).
“
Sto
“
flashes
for a short time.
When “
Sto
“ no longer flashes,
the selected parameters are stored
in the read-only memory.
After 15s “
SEL
” is indicated.
