4 / 4
P/N 1073538-EN
• REV
C
• ISS
19FEB21
2. Click the
Save Configuration
button.
Resetting the switch to default
To reset the IP address to the default IP
address
“192.168.0.100” and the user password to factory default mode
(
default password is “admin”
), p
ress the hardware reset button
on the front panel for about 10 seconds. After the device is
rebooted, log in to the management web interface within the
same subnet of 192.168.0.x and default password. Note that
all the previous setups are erased after the factory default
reset.
Figure 12: Reset button
Contact information
Europe, Middle East, and Africa
W
Go to
https://firesecurityproducts.com/en/support
Australia
E
ts@firesecurityproducts.zendesk.com
W
www.utcfs.com.au