Support
| Toll-free 1-888-284-4283
©2012 iGateWeb.com
(c) 2010 iGateWeb.com
|
clientcare@iGateweb.com
| Page 6 of 6 |
All rights reserved.
5.
Saving, applying and testing your settings
Still on the
WAN Configuration page
, you will save and apply your settings. Then you’ll proceed to test your
connection.
A)
Saving and applying your settings
It is necessary to save and apply your settings before everything will work properly:
1)
Click
Save Changes
at the bottom right-hand corner of your page
2)
Click
Apply Changes
at the bottom right-hand corner of your page
B)
Testing the Internet settings
Open a new web browser and point to
If
nothing
is displayed, go back and check the accuracy of the settings you entered in Step 4B (Entering
your Internet Service Provider settings) and Step 5 (Configure your iGateWeb filtering settings). Be
sure to follow step 6A if you make any changes again.
If a
blocked page
is displayed, you have not correctly entered the filtering settings in Step 5A. Go back
and check the accuracy of the settings you entered in Step 5A. Be sure to follow step 5 if you make any
changes again.
If
the Google.com page
is displayed, everything is working correctly. Proceed to step 6.
6.
Install the Software
The following procedure must be followed on all PCs in your network, including Desktops and Laptops. Follow these
instructions for each computer in your home / office:
o
and follow the instructions to install the required software.
o
Repeat the installation on each computer in your home / office.
o
IMPORTANT!
If you have a Macintosh Computer, please contact iGateWeb for the appropriate software
for your computer.
Congratulations! You have now correctly set up your iGate. Thanks for choosing iGateWeb!
If you need further assistance, follow the instructions as found on the sticker on the bottom of your iGate.
