131
IGEL
Technology GmbH
IGEL Zero HDX
5.09.100
Port number
Specify the port number via which the ThinPrint daemon is to communicate. Make
sure that the port number on the ThinPrint client and the ThinPrint server is the
same (communication will otherwise not be possible).
Bandwidth
Enter a bandwidth value (in bits per second) which is lower than or equal to the
value specified on the ThinPrint server. A higher value, the disabling of client
control or no entry at all means that the ThinPrint server values will be used.
Waiting time between
print attempts
Maximum waiting time (in seconds) if a printer is unavailable
Number of print
attempts
Number of attempts to contact a printer in order to start a print job.
The list of
ThinPrint
printers is shown on the
Printer
page.
Here you can manage printer configurations by adding, editing or deleting printers.
The page provides an overview of pre-configured
ThinPrint
printers:
Active
Indicates whether or not the printer is visible.
Name of the printer
Name under which the printer can be addressed.
Printer class
Name of the printer class - optional, max. 7 characters without spaces
Device
The following options are available here:
•
+ /dev/ttyS0, /dev/ttyS1, ... serial interface
•
+ /dev/lp0, /dev/lp1, ... parallel interface
•
+ /dev/usblp0, /dev/usblp1, ... USB printer
•
+ Name of a CUPS printer with LPD network printer connection: ThinPrint client
prints via the network to the LPD network printer.
•
+ Name of another CUPS printer: ThinPrint client forwards print jobs to the
appropriate printer in the CUPS printing system.
Standard
Defines the selected device as the standard printer.
9.2.
USB Storage Devices
Menu path:
Setup > Devices > Storage Devices
USB storage devices can be configured here.
9.2.1.
Hotplug storage devices
Menu path:
Setup > Devices > Storage Devices > Storage Hotplug
In this area, you can set up the connection of hotplug storage devices. These can be USB mass storage
devices or MMC card readers for example.
