25
8. Fault analysis and rectification
The device terminal strip is live during operation!!
Before working on the device disconnect it from the mains!!
flashing green LED
(1Hz):
low voltage
Uv < 180V
check power supply
permanent red LED
low water (LLW)
check feed water
flashing red LED for
4..16s
(1 Hz / DIP-switch)
followed by permanent
red LED
insulation electrode
stained
clean probe electrodes
permanent red and
yellow LEDs
system failure
restart controller by
disconnecting from and
reconnecting to power
supply;
change controller
permanent red LED
together with flashing
(1Hz) yellow LED
fault in measuring
cable
(short circuit or cable
break)
check measuring cable
Check cap 4.2, too
9. Warranty
In addition to the statutory warranty, we give a 24-month warranty on our products. The
prerequisite is proper handling in accordance with the installation and operating instructions.
In the case of wearing and replacement parts, the warranty is limited to material and
construction faults. Level probes are wearing parts and are not subject to warranty.
Gefahr
This high-quality IGEMA product was designed, manufactured and tested with the
application of the QM System guidelines in accordance with DIN EN ISO
9001:2015.
If the device supplied indicates transport damage or gives cause for complaint in
spite of our final quality control please contact our SERVICE department on
telephone
+49 2501 92424-0
.by return.
Summary of Contents for SMLC2
