9
The freezer is making a lot of noise.
1. The pipe work is touching the
wall or skirting board.
2. The freezer has not been
levelled properly.
1. Pull the freezer forward so it
does not touch the wall or
skirting board.
2. Adjust the feet at the front of
the freezer, ensuring they are
in firm contact with the floor.
The temperature in the freezer is
too warm.
1. The thermostat is set too high
temperature for your
environment.
2. The freezer is too close to a
heat source.
3. There is not enough ventilation
around the freezer
4. The door is not closed properly.
1. Turn the thermostat to a higher
number. See Adjusting the
Temperature on page 6.
2. Move the freezer away from
the heat source and out of
direct sunlight.
3. Ensure there is a minimum gap
of 10mm at each side and
30mm above the freezer.
4. Ensure that the door is properly
closed and the seal is not
damaged.
There is water underneath on the
floor.
1. There is something touching
the interior back wall of the
freezer.
1. Ensure no foods are touching
the interior back wall of the
freezer.
Disclaimer
Updates to hardware components are made regularly. Therefore some of the instructions, specifications and
pictures in this documentation may differ slightly from your particular situation. All items described in this
guide are for illustration purposes only and may not apply to your particular situation. No legal right or
entitlements may be obtained from the description made in this manual.
Fuse and Mains Plug Replacement
This product is supplied with a moulded plug, which contains
a 13A fuse. If you are simply replacing the fuse, you must use
a 13A fuse which has been approved by ASTA to BS1362.
If the plug becomes damaged, a new plug must be fitted.
Replace the original plug with a 13A (BS1363) plug and make
sure that it is fitted with an ASTA approved 13A fuse.
Never use the moulded plug without the fuse cover fitted.
To replace the plug:
1. Cut off the existing fitted plug and dispose of it.
2. The wires in the mains lead supplied with this appliance
are coloured in accordance with the following code:
GREEN/YELLOW = EARTH (E)
BLUE = NEUTRAL (N)
BROWN = LIVE (L)
This product MUST be earthed.
As the colours of the wires in the mains lead may not correspond with the colour markings identifying the
terminals in your new plug, proceed as follows:
Green/Yellow
(Earth)
Blue
(Neutral)
Brown
(Live)
CABLE
GRIP
FUSE
FUSE
COVER