iGenix IG3711BL, User Manual

7

OPERATING INSTRUCTIONS

Before using your Fridge

Before placing food in the fridge, it needs to be cleaned by wiping the interior using warm water and a 
soft cloth. Wipe the fridge completely dry before replacing the shelf.

Check that your power outlet is compatible with the plug supplied with the fridge.

IMPORTANT: Always allow at least 4 hours before turning on the fridge to allow the coolant fluid 

time to settle after the fridge is in place. Failure to do this may result in damage to the appliance and such 
damage is not covered by the guarantee.

Before placing any food in the fridge it is recommended to leave it 2 hours. This allows you to ensure the 
fridge is working correctly and gives enough time to allow the temperature in the refrigerator to drop to 
the correct level.

Using your Fridge

The ideal internal temperature of your fridge should be b0˚C to +5˚C. Before turning on the 
fridge, make sure that the temperature control, which is located at the back of the fridge is set to ‘3’ 
Allow 2 hours before placing food in the fridge to allow the temperature to fall to the correct level.
Your fridge must NOT be placed in a room where the temperature goes below 16˚C or above 32˚C for 
prolonged periods, as the internal fridge temperature will not be maintained.

•  Then install the lower hinge (2) onto the left side f the lower frame with 2 screws (8) 
•  Insert the bolt pin (9) to the lower hinge (20) 
•  Set the door to its place making sure the door sits on the lower hinge (2) 
•  While holding the door in the closed position secure the upper hinge (5) in the top frame of left  
  side with two screws (1) 
•  Please remember to not tighten the two screws (1) until the top of the door is levelled with  
  the counter top. 
•  Install the upper hinge cover (6) on the upper hinge