9
SELECT THE STEAM
The quantity of steam is regulated by the variable steam control.
1. Move the variable steam control to a position between minimum
and maximum depending on the quantity of steam required and
the temperature selected.
Warning: the iron gives off steam continuously only if you hold the
iron horizontally. You can stop the continuous steam by placing the iron
in a vertical position or by moving the steam selector to minimum/off.
As indicated on the temperature control dial and in the Preparations
table, you can only use steam at the highest temperature. If the selected
temperature is too low, water may drip onto the plate
SHOT OF STEAM AND VERTICAL STEAMING
1. Press the steam-shot button to generate a powerful burst of
steam that can penetrate the fabrics and smooth the most
difficult and tough creases. Wait for a few seconds before
pressing again.
2. By pressing the steam-shot button at intervals you can also iron
vertically (curtains, hung garments, etc.).
For the best result, there should be 5 seconds rest between each
press of the steam shot button. To prevent leaking water from the
soleplate does not press the steam shot button for more than 5
seconds continuously. Also allow the iron to rest for 1 minute
before using this function.
Warning: the steam shot button can only be used at high temperatures.
Stop the emission when the temperature control light comes on, then start
ironing again only after the light has gone off.