en
18
User manual Basia 2, Tobi
www.igloo.pl
3. PREPARING THE DEVICE FOR EXPLOITATION
3.1. Requirements concerning the place of installation
• Verify whether the cross section of feeding conduits is proper for power consumption of the installed device.
• It is forbidden to connect the device by extension rods or dividers.
• The device should be connected to the separate, properly made electric circuit with plug-in socket with protecting pin
(according to PBUE /Regulations concerning Electric Equipment Construction/)
The device may be actuated solely after con
fi
rmation of the
fi
re protection ef
fi
ciency with results of measu-
res performed according to binding regulations!
3.2. Connection and actuation
• Unpack the device and remove the wooden platform from the basis (does not concern moving devices) Fig.3 (p.18)
Fig.3 Removing the wooden platform
1 – Unscrew the feet from the platform
2 – Remove the wooden platform
3 – Screw the feet in nuts welded to the frame of the device
• Place the display cabinet on an even basis, which is hard enough, and then level it with feet.
In case of moving devices it is necessary to use wheel blockage in order to immobilise the device during exploitation
Fig.4 (p.18)
Fig.4 Wheel system, moving
system
A – moving position
B – blockade
• Remove the protection foil from the elements of the device (f. ex. from
the inside of the device, display shelves and front fender beam)
• If the user shall obtain a device partially disassembled to secure it during transportation, perform the following ope-
rations:
1. Mount display shelves or
fi
sh tanks, hanging them on aluminium angle sections Fig.5/4;5 (p.19)
2. Mount glass sides Fig.6/2;1 (p.19)
NOTE:
In case of “Gastro” display cabinets, it is necessary to pull out the universal salad tank before
mounting the glass side Fig.5 (p.19), in order to obtain free access to ABS side and to enable easy
glass side with the help of glass holding downs Fig.6/1 (p.19).
3. Mount the aluminium lamp (together with lighting) on glass sides Fig.6/3 (p.19)
4. Mount the casing of lamp conduit Fig.6/10 (p.19)
Move the casing of lamp conduit to the back of the glass side, in order to hide the conduit coming out of the lamp in
the casing and to place it on the internal part of the glass side!
5. (This concerns only “GASTRO” display cabinet) Place universal salad tank in the display cabinet. Place cross-bars
under GN containers in module tank, and then place GN containers according to Fig.2 (p.15)
6. Mount front screen Fig.6/8 (p.19)
7. Mount front glasses of the display cabinet Fig.6/5 (p.19)
8. Mount night screens Fig.7/1; 2 (p.20)
9. Place the condensate container on the basis of the device according to Fig.8/3 (p.20) or Fig.9/3 (p.20)
A
B
1
2
3
