Igloo ELBA, User Manual

en

13

User manual Elba

www.igloo.pl

2

1

4

5

7 6

3

3

10

4

3

9

8

2

1

It is essential to keep the condenser of the device 
clean. Dirt may hinder the heat exchange, causing 
mainly increase in electric energy consumption 
and may cause damage of aggregate compressor. 
In cabinets with upper aggregate it is recommended 
to clean the condenser at least once a year. Clean 
condenser lamellas with help of soft brush or paint-
brush. If the condenser is extremely dirty (blocked 
lamellas) it is indicated to use vacuum cleaner or 
compressed nitrogen to suck / blow the dirt from 
between lamellas.

The producer shall not be held responsible for damages of the condenser aggregate resulting from 
non-observance of condenser cleanliness!

Door seal should be cleaned only with clean water, without addition of washing agents, and it should be 
thoroughly dried. 

The seal cannot come in contact with greasy substances or oils! 

During maintenance services it is necessary to check whether doors close in a proper manner. 

Test: place a sheet of paper between the seal and the casing and close the door. The paper should 
pose felt resistance during an attempt of pulling it out.

During maintenance services it is necessary to pay attention not to damage the data plate of the device Fig.7 
(p.15), which contains signi

fi

 cant information for servicing organs and waste removal companies.

Do not use mechanical agents to fasten the defrosting 
process!

When using the unit as well as during maintenance work, 
be careful not to damage the temperature sensor!

1 – Lifted advertisement panel (colourless)
2 – Plexi plate of the upper panel
3 – Grips 

fi

 xing the Plexi plate

4 – Grip of the 

fl

 uorescent lamp (illumination of the upper panel)

5 – Fluorescent lamp
6 – Casing of the 

fl

 uorescent lamp and the starter

7 – Starter of the 

fl

 uorescent lamp

8 – Casing of the 

fl

 uorescent lamp

9 – Transparent casing of the 

fl

 uorescent lamp (internal illumi-

nation)

10 – Metal casing of the 

fl

 uorescent lamp (internal illumination)

Fig.5 Exchange of the 

fl

 uorescent lamps

Fig.6 Cleaning the condenser