en
18
User manual Medium-freezing and freezing cabinets
www.igloo.pl
4. EXPLOITATION
Temperature of cooled space and operating cycle of the aggregate may vary. It depends on numerous factors, such
as temperature of the surroundings and amount and temperature of products placed in the device. It is recommen-
ded to avoid unnecessary opening of the doors.
The device should be placed in a dry place, not insulated and well ventilated, ensuring proper air circulation (min. 10
cm distance between the wall and the device), far from sources of heat and devices forcing the air circulation (roof
ad mobile ventilators, blowing heaters). The device operates properly in an environment, where temperature falls
within proper climate class stated on the data plate. The operation of the device may worsen, when it will operate in
temperature higher or lower than the one determined in the stated temperature range.
Remarks and indications
• After transporting the device, wait about 2 hours before its actuation.
• The
fi
rst
fi
lling of the freezing space should be performed after its previous cooling to working temperature.
This principle should also be observed after longer pause in exploitation.
• Do not place hot products in cooling and freezing devices.
• It is forbidden to place bottles and cans with drinks in freezing devices. Their content may expand when fro-
zen, rupturing the container. Risk of injuries and damages!
• During the day it is unadvisable to place more products in the chamber of the device than its freezing capacity
can handle.
• In order to ensure proper food storage conditions, it is forbidden to fully
fi
ll the shelves. It is necessary to en-
sure even load of the shelves and do not exceed their maximal load.
• In order to prevent freezing of the packages it is essential to dry them before placing them in the device.
• Do not block any ventilation holes, which would hamper the cooled air circulation. It is necessary to ensure
proper air
fl
ow around the device (aggregate ventilation holes cannot be covered!!!!).
• Keep the condenser clean. Impurities may lead to overheating of the compressor and as a consequence may
result in damage of the device, which is not covered by warranty!
• Do not use electric devices inside grocery product storing chamber
• After closing the doors, do not try to use force to open them. Under pressure created inside the device is
equalled within 1-2 minutes, which enables free opening of the doors.
• Avoid unnecessary opening of the doors and leaving them open for a longer period of time.
4.1. Temperature regulation
“Igloo” and “Carel” thermostat (temperature regulators) service is described in chapter 7 (p. 23 and 24)
The basic aim of a thermostat is to control the cooling aggregate to obtain the set temperature within the device and
maintain it within the determined temperature ranges. The producer enters all settings of temperature regulators required
for normal functioning of the device. Before primary actuation the user should control and possibly set the required tem-
perature inside the device on the control panel.
Digital display – displays the current temperature inside the device.
It is forbidden to interfere with systemic parameters of the thermostat, as this can lead to serious consequ-
ences, including the damage of the cooling device!
Summary of Contents for EWA 500.P
